New Beetle L4-1.8L Turbo (AWP) (2003)
NOTE: Short lower cable must be in front of guide rail as shown in previous illustration
-
If vehicle has a headlining with loops, route long upper cable with cable guide through loops
-
Insert new rivet (1Y0 871 996 C) into cable guide on long upper cable, as shown
-
Place a new bushing (1Y0 871 180) over rivet and into cable guide hole
CAUTION: MAKE CERTAIN THAT RIVET IS POSITIONED INTO CABLE GUIDE AS SHOWN, OTHERWISE LONG UPPER
CABLE WILL NOT FUNCTION PROPERLY
-
Position cable guide rearward of rivet -arrow- and secure to frame
Note: If there is no hole in the frame to which cable guide can be attached, see Additional Repair Information in Section D for instructions to drill
hole
CAUTION: FOR CORRECT CABLE ROUTING, ROUNDED PORTION OF CABLE GUIDE MUST BE REARWARD OF THE
ATTACHING RIVET