New Beetle L4-1.8L Turbo (AWP) (2003)
-
Remove driver's side footwell cover
-
Disconnect connector from Clutch Vacuum Vent Valve Switch -F36-.
-
Measure resistance between switch terminals.
Specification:
-
Clutch not depressed: max. 1.5 Ohms
-
Clutch depressed: Infinity Ohms (no continuity)
If the specifications are not obtained:
-
Replace Clutch Vacuum Vent Valve Switch -F36-.
NOTE: Observe installation position of Clutch Vacuum Vent Valve Switch -F36- in bearing bracket upper assembly hole.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory.
-
Read readiness code. If DTC memory has been erased or Motronic Engine Control Module (ECM) -J220- was disconnected from battery positive,
readiness code must be generated again.
If the specifications are obtained:
-
Connect multimeter using auxiliary cables from VAG 1594 to measure voltage between terminal 2 and Ground (GND).
-
Switch on ignition.
Specification: min. 11.5 V
If the specification is not obtained:
-
Check wiring for open circuit between connector terminal 2 and central electrics using Electrical Wiring Diagram.
If the specification is obtained:
-
Remove inner plenum chamber cover, left
-
Connect VAG 1598/31 test box to control module wiring harness. Motronic Engine Control Module (ECM) -J220- is not connected by this action.