New Beetle L4-1.8L Turbo (AWP) (2003)
Camshaft Position Sensor: Testing and Inspection
With Generic Scan Tool
Check Camshaft Position (CMP) sensor
Recommended special tools and equipment
-
VAG1526 multimeter or VAG1715 multimeter
-
VAG1594 connector test kit
-
Wiring diagram
Test requirements
-
The respective fuses of Motronic Engine Control Module (ECM) - J220- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as, for example, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
Ground (GND) connections between engine and chassis must be OK.
Test sequence
-
Disconnect 3-pin connector -1- from Camshaft Position (CMP) sensor -2-.
-
Connect multimeter to terminal 1 (B+) and 3 (Ground -GND-) of the respective connector for Camshaft Position (CMP) sensor for voltage
measurement.
-
Switch ignition on.
Specified value: at least 4.5 V
-
Switch ignition off.
If there is no voltage:
-
Connect test box to control module wiring harness, connect test box for wiring test.