New Beetle L4-1.8L Turbo (AWP) (2003)
-
Disconnect 2-pin connector from Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- (arrow).
Continuation for all vehicles
Checking resistance
-
Measure resistance between terminals of solenoid valve.
Specified value: 22.0 to 30.0 ohms
If specified value is not obtained:
-
Replace Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check wires to control module according to wiring diagram.
Check wires to control module
-
Connect test box to control module wiring harness
Vehicles with engine code APH
-
Check wire between test box and 2-pin connector for open circuit according to wiring diagram.
terminal 2 + socket 64
Wire resistance: max. 1.5 ohms