Testing and Inspection for Knock Sensor
If the malfunction is still present:
-
Replace Knock Sensors (KS) -G61- or -G66-, item 12 or item 13.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic
Trouble Codes
-
Read readiness code. If DTC memory has been erased or Engine Control Module was disconnected from battery positive, readiness code must be
generated again.
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes