New Beetle L4-1.8L Turbo (AWP) (2003)
^
VAG 1459 B Hydraulic removal and installing tool for wheel bearing
^
Hollow piston cylinder HKZ-15 with hydraulic press piece E-0-204T
^
Pull rods E-0-217+218
^
Special nut E-8-214
^
Thrust piece E-5
^
Thrust piece E-10
^
Thrust piece E-13-1
^
Press piece E-65-1
^
Thrust bolt E-15
^
VAG 1459 B/2 Supplementary set
^
Support E-40
-
Lift vehicle until the load on the front axle is relieved.
-
Loosen 12-point nut.
-
Remove wheel.
-
Press drive axle out.
Note:
-
When pressing drive axle out make sure sufficient play is available.
-
Remove both guide pins from the brake caliper.
-
Remove brake caliper and brake disc.
-
Secure brake caliper to body with wire.
-
Remove cover plate.
-
Remove coupling link from control arm.
-
Release wheel speed sensor wiring from suspension strut.
-
Pull wheel bearing housing with ball joint out from control arm.
-
Remove drive axle from wheel bearing housing and tie up.