New Beetle L4-1.8L Turbo (AWP) (2003)
Special tools and equipment
^
2050 Thrust piece
^
3235 Press
^
V.A.G. 1331 Torque wrench
^
1-Kukko 21/7 Internal puller
^
4-Kukko 22/2 Counter support
It is necessary to readjust the output shaft when the following components are replaced:
^
Transmission housing
^
Clutch housing
^
Output shaft for 5th, 6th and reverse gears
or
^
Tapered roller bearing
Adjustment overview, Refer to Differential,Manual Transaxle, Adjustment, Adjustment Overview
Requirements
^
Sealing surfaces of clutch and transmission housings must be free of sealant.
^
When taking measurements, install only the shaft to be measured.