New Beetle L4-1.8L Turbo (AWV) (2005)
-
Connect multimeter between connector terminal 1 (B+) and 3 (Ground (GND)) for voltage measurement.
-
Switch ignition on.
Specified value: at least 4.5 V
-
Switch ignition off.
If there is no voltage:
-
Check wires to control module according to wiring diagram.
Check wires to control module
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
-
Check wires between test box and 3-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 1 + socket 98
Terminal 2 + socket 86
Terminal 3 + socket 108
Wire resistance: max. 1.5 Ohms
-
Check wires for short circuit to each other.
Specified value: Infinite Ohms
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in the wires and there was voltage between terminals 1+3:
-
Replace Camshaft Position (CMP) Sensor -G40-:
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes