New Beetle L4-1.8L Turbo (AWV) (2005)
-
Connect Multi-Function Transmission Range (TR) Switch -F125- (-4-) to shift rod -6-.
-
Screw in mounting bolts -5- for multi-function switch hand-tight.
-
Place setting gauge (T10173) on shift rod -2-.
-
Rotate Multi-Function Transmission Range (TR) Switch -1- until tab on connector engages in groove of adjustment tool.
-
Fasten setting gauge T10173 onto shift rod -2- using bolt -3-.
-
Tighten mounting bolts (arrows) of Multi-Function Transmission Range (TR) Switch.
Tightening torque: 6 Nm
-
Remove adjustment tool (T10173) from shift rod.
Rest of installation is in reverse order of removal.
-
Check adjustment of selector lever cable.
-
Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes