New Beetle L4-1.8L Turbo (AWV) (2005)
-
Check resistance between terminals 2 + 3 of switch.
Specified value
Clutch pedal not depressed: max. 1.5 Ohms
Clutch pedal depressed: Infinite Ohms
Continue for all vehicles
If specified values are not obtained:
-
Replace Clutch Pedal Switch h -F36-.
NOTE: Note installation position of clutch vacuum vent valve switch in the upper installation bore of mounting bracket.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain Management/Computers
and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase
Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If specified values are obtained:
-
Check voltage supply of clutch pedal switch and wiring to control module.
If voltage supply and wires are OK:
-
Replace Motronic Engine Control Module (ECM) -J220-.
Checking voltage supply and wiring to control module
Vehicles with 2-pin clutch vacuum vent valve switch
-
Connect multimeter between terminal 1 and Ground (GND) for voltage measurement.
-
Switch ignition on.
Specified value: at least 11.5V
-
Switch ignition off.