New Beetle L4-1.8L Turbo (AWV) (2005)
-
Fit Multi-function TR switch -F125- - 4 - onto selector shaft - 6 -.
-
Tighten multi-function TR switch securing bolts - 5 - hand tight.
-
Fit locking plate - 2 - and washer - 3 - onto selector shaft - 6 -.
Note:
-
Fit locking plate - 2 - with hooks facing up.
-
Fit locking plate - 2 - with long thin guides into long, thin recesses of selector shaft - 6 -.
-
Tighten nut - 1 - to 7 Nm.
-
Secure nut - 1 - by bending up hooks on locking plate - 2 -.
Note: If one or more hooks of the locking plate break off while bending, replace the locking plate.
-
Install lever - 3 - onto selector shaft - 4 -.
-
Switch transmission to position "P" using lever - 3 - by pushing lever - 3 - toward rear of vehicle onto limit stop.
-
Select position "N" on transmission using lever - 3 - (Move lever - 3 - two detents toward front of vehicle).
-
Fit spring ring - 2 - and nut - 1 - onto selector shaft - 4 -.
-
Tighten nut - 1 - to 13 Nm.
Adjusting
-
Move selector lever to position "N".
Note: Do not kink the selector lever cable.
Requirements
-
Selector lever cable is disconnected at selector shaft lever.
-
Selector shaft positioned at "N".