New Beetle L4-1.8L Turbo (AWV) (2005)
-
Pull off wheel hub/wheel bearing unit from stub axle.
-
A - Puller, e.g. Kukko 20/2
-
Pull off bearing inner race from stub axle.
-
Only use puller - A - with tension bracket, e.g. Kukko 204-2 (commercial type).
Installing
-
Push wheel bearing/wheel hub unit onto stub axle as far as it will go.
-
Screw on Installation Sleeve wheel Brg. 3420 and pull on wheel bearing/wheel hub unit until it stops.
-
Make sure that wheel hub/wheel bearing unit is not canted!
-
Remove Installation Sleeve wheel Brg. 3420.
-
Use a new 12-point nut - A - and tighten.
-
Install brake disc.