New Beetle L4-1.8L Turbo (AWV) (2005)
Shift Cable: Service and Repair
Selector lever cable, removing and installing, 09G, 6 Spd. A/T
Removing
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
Move selector lever to Tiptronic gate.
-
With ignition switched off disconnect battery Ground strap.
-
Disconnect intake hose - 1 - and connector - 2 - from mass air flow sensor.
-
Disconnect secondary air injection pump hose - 3 - from air cleaner housing.
-
Remove bolts - 4 -, - 5 - and - 6 -.
-
Remove air cleaner complete.
-
Press selector lever cable - 1 - off selector shaft lever - 3 - with, e.g. 10 mm open end wrench - 2 -.
-
Press locking devices on selector lever cable support mounting together - arrows - and pull selector lever cable out of transmission support
mounting.
-
Remove selector lever cable - 1 - from clip - arrow - on transmission.
-
Raise vehicle.