New Beetle L4-1.8L Turbo (BNU) (2005)
/Page-2403008.png)
Adjusting slack -B-.
Adjusting slack -C and -D-.
Large and small trims can show a different height with respect to side panel trim.
-
Heights -A- and -B- should be identical to that of side panel trim in order to avoid jamming or damage to trims whenever they are opened or
closed.
Adjusting trim height -A-.
Adjusting trim height -B-.
Adjusting slack A
-
Remove side panel trim.
-
Unclip push rod -2-.
-
Open trim -4-.
-
Loosen bolts/screws -1-.
-
Align flap module -3- in -direction of -arrows-.
-
Tighten screws/bolts -1- (3 Nm).
-
Close trim -4-.
-
Clip in push rod -2-.
-
Check slack -A- 3.5...4.5 mm and adjust if necessary.
-
Install side panel trim.
Adjusting slack B
-
Remove side panel trim.
