New Beetle L4-1.8L Turbo (BNU) (2005)
-
Recheck position of camshafts relative to one another -arrows-
The rest of the assembly is basically a reverse of the disassembling sequence.
Installing toothed belt and adjusting timing. See: Timing Components/Timing Belt/Service and Repair/Procedures
Note:
After installing new lifters the engine must not be started for approximately 30 minutes. Hydraulic compensation elements must settle
(otherwise valves will strike pistons).
Camshaft Adjustment, Servicing
Camshaft Adjustment, Servicing (Vehicles With Engine Code AWP, AWV, BKF, BNU)
1. Double bearing cap
2. 10 Nm
3. Exhaust camshaft bearing cap
4. Exhaust camshaft
5. Intake camshaft bearing cap
6. Intake camshaft
7. Drive chain
-
Mark direction of travel (installation position) before removing