New Beetle L4-1.8L Turbo (BNU) (2005)
8 - Thrust washer
^
For bearing 3 bearing cap
^
Note fixing arrangement
^
Lettering faces mounting bracket
9 - Crankshaft
^
Axial clearance:
-
New: 0.070.23 mm
-
Wear limit: 0.30 mm
^
Check radial clearance with Plastigage
-
New: 0.010.04 mm
-
Wear limit: 0.15 mm
^
Do not rotate crankshaft when checking radial clearance
10 - Thrust washer
^
For bearing 3 bearing cap
^
Spare part version (2 part), lower thrust washers are only semicircular
^
Note fixing arrangement
^
Lettering faces mounting bracket
11 - Bearing shells 1, 2, 4 and 5
^
For bearing cap without oil groove
^
For cylinder block with oil groove
^
Do not interchange used bearing shells (mark)
^
Classification for ordering spare parts.
12 - Chain sprocket
^
For oil pump drive
Crankshaft bearing shell identification for cylinder block (gradual introduction)
During production a bearing shell of the correct thickness is allocated to the cylinder block. Colored marks are used to identify the thickness of the
bearing shells.
Note:
^
The - arrow - shows the direction of travel.
Which thickness of shell should be installed to which location is marked by a letter on the lower sealing surface of the cylinder block.
Color code