New Beetle L4-1.8L Turbo (BNU) (2005)
Valve Seat: Service and Repair
Valve seats, reworking
Special tools, testers and auxiliary items required
^
Depth gauge
^
Valve seat refacing tool
Note:
^
When repairing engines with leaking valves, it is not sufficient to rework or replace valve seats and valves. It is also necessary to check the valve
guides for wear. This is particularly important on high mileage engines.
^
Valve seats should be reworked only enough to produce a perfect seating pattern. Before beginning to rework valve seats, calculate the maximum
permissible reworking dimensions. If the reworking dimension is exceeded, hydraulic valve compensation can no longer be guaranteed and the
cylinder head should be replaced.
The maximum permissible reworking dimension is calculated as follows:
-
Insert valve and press firmly against seat.
Note:
^
If the valve is to be replaced as part of a repair, use a new valve for the calculation.
-
Measure vertically distance - a - between end of valve stem and upper edge of cylinder head - 1 -.
-
Calculate max. permissible reworking dimension from measured distance and minimum dimension.
Minimum dimension:
-
Outer intake valves 31.0 mm
-
Center intake valve 32.3 mm
-
Exhaust valve 31.9 mm
Measured distance minus minimum dimension = max. permissible reworking dimension.
^
The maximum permissible reworking dimension is shown on illustrations for reworking valve seats as dimension "b".