New Beetle L4-1.8L Turbo (BNU) (2005)
Alignment: Service and Repair
Test Requirements
Test requirements:
-
Check suspension, wheel bearing, steering and steering linkage for excessive play and damage
-
Tread depth difference of no more than 2 mm on an axle
-
Tires inflated to prescribed pressure
-
Curb weight of vehicle
-
Fuel tank must be full
-
Spare tire and vehicle tools are installed in appropriate position in vehicle
-
The water container for the windshield/headlight cleaning system must be full.
-
Be sure that the sliding plates and turn tables are not touching the end stop when checking wheel alignment
Note: Test equipment must be properly adjusted and attached to the vehicle (see equipment manufacturers instructions)!
-
If necessary, contact the manufacturer for familiarization with the proper use of the equipment.
-
After a certain period, wheel alignment platforms and computer equipment can lose their original leveling setting and adjustments.
-
Wheel alignment platforms and wheel alignment analyzer/computer should be serviced and calibrated at least once a year.
-
Precision equipment of this type should be treated with due care and knowledge.