New Beetle L4-1.9L DSL Turbo (ALH) (2003)
-
Use new button, adjuster, pin and clip from repair kit (1YM 898 002)
-
Place and hold new adjuster with rubber washers in position in the latch bracket so the bottom groove on the adjuster aligns with latch bar in
release handle
NOTE:
-
Previously removed rubber washers -8- need to be reinstalled
-
Arrows in illustration show position of latch bracket. Rubber washers are inward of the bracket and adjuster -9- is in the middle
-
To install new button, hold it in previously noted position before disassembly and rearward of the latch bracket, then move button forward over
latch bracket and insert new pin
-
Raise release handle over new button
-
Press button and check function
-
Install new clip on pin
-
Proceed to Section C
Section C
Section C - Headlining Tensioning System Repair
TO BETTER UNDERSTAND THE FOLLOWING WORK SEQUENCE, PLEASE REFER TO THE PICTURES WHICH IDENTIFY THE
ASSEMBLED HEADLINING TENSIONING CABLE ROUTING AND DESCRIPTIONS:
NOTE: All illustrations in this section are showing right side of vehicle unless identified as a left side illustration