New Beetle L4-2.0L (AVH) (2005)
-
Cut fabric stitching on detached piece of plastic ring -arrows-.
-
Remove detached piece of plastic ring. If necessary, increase the cutout to 4 mm, 5 mm, or 6 mm to allow for a better fit of the plastic ring.
-
To prevent fabric stitching from unraveling, apply 3M(TM) Automix(TM) Quick Fix Adhesive (Part No. 08224) to stitching locations shown
-arrows-.
-
To quick dry adhesive, spray 3M(TM) Automix(TM) Quick Fix Adhesive Accelerator (Part No. 08224) to adhesive.
WARNING:
Always read and follow Manufacturers Cautions and Warning on product.
Tip:
Obtain 3M(TM) Automix(TM) Quick Fix Adhesive Kit at your local 3M(TM) Automix(TM) authorized distributor.
-
Turn headliner over, to expose fabric side.
-
To prevent fabric stitching from unraveling, apply 3M(TM) Automix(TM) Quick Fix Adhesive (Part No. 08224) to stitching locations shown
-arrows-.
-
To quick dry adhesive, spray 3M(TM) Automix(TM) Quick Fix Adhesive Accelerator (Part No. 08224) to adhesive.
-
Install headliner. See Repair Manual, Convertible top, Repair Group 61.
-
Use soft jawed pliers to install plastic ring in rear glass channel.
Tip: Do not use rubber hammer to install plastic ring in rear glass channel.
If plastic ring is still too large to be installed.