New Beetle L4-2.0L (AVH) (2005)
6 - Sender wheel
^
Replace
^
For Engine speed (RPM) sensor -G28-
^
Can only be installed in one position. Holes are offset
7 - 10 Nm plus 1/4 turn (90°)
^
Replace
8 - Thrust washer
^
For bearing 3 bearing cap
^
Note fixing arrangement
^
Lettering faces side of bearing bracket
9 - Crankshaft
^
Axial clearance:
-
New: 0.07 to 0.23 mm
-
Wear limit: 0.30 mm
^
Check radial clearance with Plastigage
-
New: 0.01 to 0.04 mm
-
Wear limit: 0.15 mm
^
Do not rotate crankshaft when checking radial clearance
10 - Thrust washer
^
For cylinder block, bearing 3
^
Version for spare part (2 parts), bottom thrust washers are only half circles
^
Note fixing arrangement
^
Lettering faces side of bearing bracket
Identification of crankshaft bearing shells for cylinder block (gradual introduction)
During production a bearing shell of the correct thickness is allocated to the cylinder block. A color code is used to identify the thickness of the
bearing shells.
Note:
^
The - arrow - points forward.
Which thickness of bearing shell should be installed at which point is marked with a letter on the underside of the sealing surface of the cylinder block
- x -.
Color code
Note:
If the color code is not stamped or is not legible then use the middle sized (red) bearing shell.