New Beetle L4-2.0L (AVH) (2005)
1 - Piston rings
^
Gaps offset by 120°
^
Remove and install using piston ring pliers
^
"TOP" faces piston crown
2 - Piston
^
Mark installation position and cylinder number
^
Arrow on piston crown points to belt pulley end Install using piston ring clamp
3 - Connecting rod
^
Replace as set only
^
Mark cylinder number - B -
^
Installation position: Marking - A - faces belt pulley end
4 - Connecting rod bearing cap
^
Mark cylinder number - B -
^
Installation position: Marking - A - faces belt pulley end
5 - 30 Nm plus 1/4 turn (90°)
^
Replace
^
Oil threads and contact surfaces
^
To measure radial clearance, tighten to 30 Nm, but do not turn further
6 - Pressure relieve valve, 27 Nm
7 - Oil spray jet
^
For piston cooling
8 - Bearing shell
^
Note installed position
^
Do not interchange used bearing shells
^
Ensure retaining lugs fit tightly in recesses
^
Upper bearing shell with oil drilling for piston pin lubrication