New Beetle L4-2.0L (AVH) (2005)
-
Difference between actual and nominal diameter: not more than 0.04 mm
Checking cylinder bores
Special tools, testers and auxiliary items required
Internal dial gauge 50100 mm
-
Take measurements at 3 positions in both lateral - A - and longitudinal - B - planes, as illustrated.
-
Difference between actual and nominal diameter: not more than 0.08 mm
Note:
^
Measuring the cylinder bores must not be done when the cylinder block is mounted on a repair stand with holding fixture VW540 and spacers VW
540/1 B, as incorrect measurements would then be possible.
Piston with industrially cracked connecting rod
Note:
^
When working on the engine, it should be secured with the Holding fixture VW540 and the Spacers VW 540/1 B to the support clamp.