New Beetle L4-2.0L (AVH) (2005)
-
Difference between actual and nominal diameter: not more than 0.04 mm
Installation position of bearing shells
Bearing shell - 1 - with oil drilling - arrow - for connecting rod.
Bearing shell - 2 - with no oil drilling for connecting rod bearing cap.
-
Insert bearing shells centralized in connecting rod and connecting rod bearing cap.
-
Dimension - a - must be same on left and right sides.
Checking cylinder bores
Special tools, testers and auxiliary items required
^
Internal dial gauge 50 to 100 mm
-
Take measurements at 3 positions in both lateral - A - and longitudinal - B - planes, as illustrated.
-
Difference between actual and nominal diameter: not more than 0.08 mm
Note:
^
Measuring the cylinder bores must not be done when the cylinder block is mounted on a repair stand with holding fixture VW540 and spacers VW
540/1 B, as incorrect measurements would then be possible.