New Beetle L4-2.0L (AVH) (2005)
1. Tensioner roller
2. Pulley - Generator (GEN)
3. Pulley - A/C compressor
4. Ribbed belt - Tensioner roller, generator, a/c compressor, power steering pump and crankshaft/vibration damper
5. Pulley - Power assisted steering vane pump
6. Pulley - Crankshaft/vibration damper belt
Ribbed Belt - 4-Cylinder Gasoline Engine, Removing and Installing
Ribbed Belt - 4-Cylinder Gasoline Engine, Removing and Installing
CAUTION:
-
Always replace ribbed belt if found to be faulty. This will avoid related break-downs or operating problems.
-
If a used ribbed belt is to be reused, mark direction of rotation before removing. When installing used ribbed belts observe the direction of rotation
marked on removal. Installing opposite to the direction of rotation leads to belt damage!
-
It is not necessary to adjust the ribbed belt tension, as a spring loaded tensioner guarantees the best possible belt tension.
Special tools, testers and auxiliary items needed
-
3090 Rod Support
Removing
-
Lift vehicle.
-
Remove screws -arrows- on each side of the insulation cover.
-
Lower and remove cover.