New Beetle L4-2.0L (AVH) (2005)
-
Carefully pry off clutch plate using two large screwdrivers -A-.
Use locally available 2 or 3 arm puller if plate is securely seated (difficult to remove).
Clutch pulley, removing
-
Remove circlip key -4-.
-
Attach commercially available 2 arm puller -A- on shoulder -B- and pull off pulley.
Clutch coil, installing
-
Install coil on compressor.
-
Locate locking pin on coil -A- into recess -C-.
Clutch plate gap, checking
-
Gap: 0.4 - 0.8 mm (0.015 - 0.023 in)
Determine "Dimension 1"
-
Using depth gauge -1-, measure gap between top of clutch plate -3- and clutch pulley -2- at three equally spaced locations (measurement must not
deviate).