New Beetle L4-2.0L (AVH) (2005)
/Page-2937001.png)
Headlamp Alignment Control Module: Service and Repair
Left High Intensity Gas-Discharge Lamp (With Range Control) Control Module -J567-, Removing
and Installing
Left High Intensity Gas-Discharge Lamp (With Range Control) Control Module -J567-, Removing and Installing
WARNING:
-
HIGH VOLTAGE
-
Always disconnect negative ( - ) battery terminal prior to servicing any parts of the HID lamp system marked with the yellow "HIGH
VOLTAGE!"symbol.
-
After disconnecting battery, briefly turn headlights on and off in order discharge any residual voltage.
The (master) control module is located in the left front wheel housing.
Removing
-
Remove left front wheel housing liner.
-
Remove nuts/bolts -1- for control module.
-
Disconnect electrical connection -2-.
Installing
Installation in reverse sequence of removal.
-
Check headlight function.
-
Code control module (function 07) using On Board Diagnostic program.
-
Perform headlight basic setting (function 04) using On Board Diagnostic program.
