New Beetle L4-2.0L (AVH) (2005)
-
Turn crankshaft to TDC No.1 cylinder (vehicles with an automatic transmission).
Engine removed
-
Position vibration damper at TDC No. 1 cylinder - arrows -.
Continued for engine removed or installed
-
Install toothed belt on tensioning roller and camshaft pulley.
Tensioning toothed belt
Requirements
^
Engine must be no more than warm to touch.
^
Camshaft positioned at TDC for cylinder 1.
^
Before tensioning toothed belt, turn tensioning roller 5 times to limit stop (in both directions) at eccentric using toothed belt tensioner T10020.
Work sequence
-
Turn eccentric to left (direction of arrow) onto limit stop using toothed belt tensioner T10020.
-
Relieve tension on toothed belt until notch - 1 - and indicator - 2 - are aligned (use mirror).
-
Tighten securing nut to 20 Nm.
-
Turn crankshaft two rotations in engine direction of rotation until engine is on TDC No. 1 cylinder again. When doing this it is important that last
45° (1/8 turn) is completed without interruption.
-
Check tension of toothed belt again.
-
Specification: indicator and notch align