New Beetle L4-2.0L (AVH) (2005)
-
Check resistance for sensor heater at connector to oxygen sensor terminal 1+2.
-
Specified value: 1.0 to 20.0 Ohms (at room temperature)
If specified value is not obtained:
-
Replace Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130-:
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check Ground (GND) activation of oxygen sensor heater.
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
Vehicles with engine code AEG
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Terminal 2 + socket 28
Wire resistance: max. 1.5 Ohms
Vehicles with engine code AVH, AZG, BDC, BEV, BGD