New Beetle L4-2.0L (AVH) (2005)
Oxygen Sensor: Testing and Inspection
Oxygen Sensor Heater For Oxygen Sensor Behind Three Way Catalytic Converter (TWC), Checking
Oxygen Sensor Heater For Oxygen Sensor Behind Three Way Catalytic Converter (TWC), Checking
NOTE:
-
Vehicle must be raised before connector for oxygen sensor is accessible.
-
When servicing terminals 3 and 4 in harness connector of Heated Oxygen Sensor (HO2S), use only gold-plated terminals.
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Requirements
-
The respective fuses of Oxygen Sensor (O2S) Behind Three Way Catalytic Converter (TWC) -G130- must be OK.
-
Ignition switched off.
Work sequence
-
Remove protective cover (arrows) and disconnect 4-pin harness connector (brown) -1- to Oxygen Sensor (O2S) behind Three Way Catalytic
Converter (TWC) -G130-.