New Beetle L4-2.0L (AVH) (2005)
Transmission Position Switch/Sensor: Testing and Inspection
Multi-Function Transmission Range (TR) Switch, Checking
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Requirements
-
Respective fuses must be OK:
-
Instrument Cluster Control Module -J285- in instrument cluster must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
Selector lever must be in -P- position.
-
Ground (GND) connections to transmission must be OK.
Function test
-
Switch ignition on.
-
Depress brake pedal and maintain depressed.
-
Shift into all selector lever positions.
-
Selector lever position must correspond to display of Instrument Cluster Control Module -J285- in instrument cluster.
-
Switch ignition off.
If selector lever position does not correspond to display of Instrument Cluster Control Module -J285- in instrument cluster:
Vehicles with 01 M transmission
-
Disconnect 8-pin harness connector to Multi-Function Transmission Range (TR) switch -F125-.
Vehicles with 09G transmission
-
Disconnect 10-pin harness connector -2- to Multi-Function Transmission Range (TR) switch -F125-.