New Beetle L4-2.0L (AVH) (2005)
/Page-1231002.png)
-
Use multimeter and adapter cables to measure voltage supply between terminals 1 + 6 of disconnected connector.
-
Switch on ignition.
Specified value: at least 11.5V
-
Switch ignition off.
If there is no voltage:
-
Check wire between 6-pin connector terminal 6 and Motronic Engine Control Module (ECM) power supply relay -J271- for open circuit according
to wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Check wires between 6-pin connector terminal 1 and Ground (GND) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
If there is no malfunction in voltage supply:
-
Check activation.
Checking activation
WARNING: Do not touch ignition coil connecting parts or adapter cables during the following test.
