New Beetle L4-2.0L (AVH) (2005)
/Page-93002.png)
-
Repeat coding.
If the code number entered, is not accepted by the control unit, the display will show:
Indicated on display:
FAULT ->
Coding 00200 not accepted
In this case the control unit has not been programmed with the relevant data for the vehicle.
A check must then be completed to see if the correct control unit for the vehicle has been installed (compare Part No. and letter index), or whether an
incorrect code number has been entered.
-
Repeat coding.
If the control unit cannot be coded (correct control unit, correct code number), the control unit is faulty.
Ending function:
-
Press -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
-
Press buttons -0- and -6- to end the output.
-
Confirm entry with -Q- button.
Indicated on display:
Rapid data transfer Q
06 End output
-
Switch off ignition.
-
Disconnect connection to scan tool V.A.G 1551.
