New Beetle L4-2.0L (AVH) (2005)
Shift Interlock Solenoid: Service and Repair
Shift lock solenoid -N110-, removing and installing, 09G, 6 Spd. A/T
Removing
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
Move selector lever to position "R".
-
With ignition switched off disconnect battery Ground strap.
-
Remove selector mechanism and printed circuit board cover Selector mechanism and printed circuit board cover, removing and installing.
-
Disconnect connector - arrow - from Shift lock solenoid -N110-.
-
Move pull rod upward and shift selector lever to position "P" with pull rod still held up.
-
Raise vehicle.
-
Loosen double clamp - A - and slide to rear.
-
Remove tunnel bridge - B - located beneath exhaust system.
-
Remove heat shields - C - and - D -.
-
First remove 4 nuts - arrows A -.
-
Remove 2 bolts - arrows B -.
-
Carefully slide cover with protective covering forwards over selector lever cable.