New Beetle L4-2.0L (AVH) (2005)
-
Put wheel bearing - 1 -, pressure piece - 2 - (put collar into bearing), and hollow piston cylinder - 3 - with tie bolt on wheel bearing housing.
-
From inside, assemble pressure piece - 4 - with wide collar to wheel bearing housing and special nut - 5 -.
-
Press in wheel bearing by actuating pump.
-
Insert securing ring with needle-nose pliers.
1 - Wheel bearing
2 - Thrust piece E-13-1
3 - Hollow piston cylinder HKZ-15
4 - Thrust piece E-10
5 - Special nut E-8-214 and tie bolt
Pressing in wheel hub
-
Put wheel hub - 1- and hollow piston cylinder - 2 - with tie bolt onto wheel bearing.
-
From inside, assemble special nut - 4 - and pressure piece - 3 - with collar to special nut.
-
Press in wheel hub by actuating pump.
1 - Wheel hub
2 - Hollow piston cylinder HKZ-15
3 - Thrust piece E-5
4 - Special nut E-8-214 and tie bolt
-
Installation is in reverse order of removal. Note the following:
-
Tighten bolts for control arm and ball joint on to old marks.
-
Install wheel and tighten.