New Beetle L4-2.0L (AZG) (2003)
-
If the window is not outboard 1.0 mm adjust the glass as follows:
-
On the bottom of the door at the front and rear, remove rubber plugs covering nuts -A-
-
Loosen nuts -A- and adjust window in/out position -arrow- equally to achieve the 1.0 mm outward window position and tighten nuts
NOTE: Sliding nuts outward brings the window inward at the top
-
Tighten nuts and replace rubber covers when window is in the correct position
-
Open door and place 3 pieces of tape along the top of the window as indicated in the illustration -arrows-
-
Close door and mark the depth of window entry into the window slot
-
Open door and using a scale measure the window entry depth
-
Depth needed is 8 mm±1 (.28 in. - .35 in.)
NOTE: This the Z - axis window adjustment
-
Remove rubber plugs on the bottom of the door, use a T30 Torx driver and turn screw clockwise to raise window or counterclockwise to lower
window to get to the required depth
NOTE: By turning the Torx screw one revolution, the window will move 1 mm (0.04 in.)
-
Turn ignition switch to the "ON" position
-
Press and release the latch button -arrow 7- and pull the locking handle down
NOTE: DO NOT pull on the latch release button
-
Turn the handle -arrow 4- counterclockwise until it stops, then push the convertible top upward, open it slightly and release the handle