New Beetle L4-2.0L (AZG) (2003)
NOTE: Sliding nuts outward brings window inward at the top
-
Tighten nuts and replace rubber covers when window is in correct position
-
Open door and place three pieces of tape along the top of the window as indicated in illustration -arrows-
-
Close door and mark depth of window entry into window slot
-
Open door; use a scale to measure window entry depth
-
Depth needed is 8 mm±1 (.28 in. - .35 in.)
NOTE: This is the Z - window adjustment.
-
Remove rubber plugs on bottom of door; use a T30 Torx driver and turn screw clockwise to raise window or counterclockwise to lower window to
reach required depth
NOTE: By turning Torx screw one revolution, window will move 1 mm (0.04 in.)