New Beetle L4-2.0L (AZG) (2003)
/Page-321004.png)
1. Suspension strut
2. Self-locking nut
^
Always replace
^
60 Nm (44 ft. lbs.) plus additional 90° turn
^
Never less than 90°!
^
Turning angle tolerance 90° to 120°
3. Wheel bearing housing
For vehicles:
^
With 85 kw (115 Hp) gasoline engine
^
With TDI engine
4. Tie rod end
5. Splash plate
6. Hex. bolt
^
10 Nm (7 ft. lbs.)
7. Wheel bearing
^
Pressing out, Refer to Fig. 4
^
Always replace, as it is destroyed during pressing out
^
Pressing in, Refer to Fig. 5
8. Circlip
^
Make sure clip is correctly seated
9. Wheel hub with ABS wheel speed sensor rotor
^
Rotor is welded to wheel hub
^
Check rotor for lateral run-out
10. Guide pins
^
28 Nm (20 6 ft. lbs.)
11. Protective cap
12. Brake caliper
Vehicles:
^
With 85 kw (115 Hp) gasoline engine
^
With TDI engine
^
Servicing
