New Beetle L4-2.0L (AZG) (2003)
Accelerator Pedal: Service and Repair
Kick Down Point, Learning
After replacing the engine control module or the accelerator pedal, vehicles with automatic transmissions must relearn the kick-down point.
Test conditions
-
Ignition on, engine not running
Work sequence
-
Connect scan tool VAG 1551 (V.A.G 1552). Switch ignition on and select engine control module with "Address word" 01.
Connecting scan tool and selecting Engine Control Module (ECM).
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons 0 and 4 for function "Introduction of basic setting" and confirm entry with Q button.
Indicated on display
Basic setting
Input display group number XXX
-
Press the buttons 0, 6 and 3 for "Display group number 63" and confirm with Q button.
Indicated on display
System in basic setting 63
->
1
2
3
4
-
Observe display in display zones 3 and 4:
Display: Operate kick down
-
Press accelerator pedal beyond kick- down pressure point to floor.
-
Hold pedal at this point for at least 2 seconds.
-
Observe display in display zones 3 and 4:
Specification: Kick Down ADP. runs then
Specification: Kick Down ADP. OK
-
Appears in display zones 3 and 4:
Display: Kick Down ERROR
-
End engine basic setting by pressing the -> button.
-
Press buttons 0 and 6 for function "End output" and confirm entry with Q button.
-
Check accelerator position sensor: