Volkswagen Workshop Manuals
New Beetle L4-2.0L (AZG) (2003)
Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Electronic Throttle Control Module > Component Information > Testing and Inspection > Page 213
Indicated on display: (1 to 4 = display zones)
Basic setting 60
Adapting has been performed successfully.
End engine basic setting by pressing -> button.
Press buttons 0 and 6 for function "End output" and confirm entry with Q button.
To store the values:
Switch ignition off for at least 50 seconds (control module run-on).
Switch ignition off.
If the basic setting of the control module is interrupted, the cause could be one of the following:
The test conditions were not fulfilled.
Throttle valve control module is malfunctioning or there is a malfunction in the wiring.
After an interruption a DTC is stored in DTC memory. When next switching on ignition the basic setting is automatically performed again.
|[PREV PAGE] [NEXT PAGE]|