Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


New Beetle L4-2.0L (AZG) (2003)

Relays and Modules > Relays and Modules - Transmission and Drivetrain > Relays and Modules - A/T > Control Module, A/T > Component Information > Technical Service Bulletins > Page 318

Page 1
background image

Control Module: Service and Repair

The control module (arrow) is located in the plenum chamber, center right.

Removing TCM -J217- 
^

Switch off ignition.

^

Remove inner cover of plenum chamber.

^

Disconnect multi-pin connector, then remove connector from control module.

^

Remove screws (arrows).

^

Remove control module.

Installing TCM -J217- 
Install the TCM in the reverse order of removal and note the following:

^

Locate multi-pin connector on TCM -J217- pins (arrows) then lock connector.

^

Perform On Board Diagnostic (OBD).

^

Initiate basic setting.

Relays and Modules > Relays and Modules - Transmission and Drivetrain > Relays and Modules - A/T > Control Module, A/T > Component Information > Technical Service Bulletins > Page 318

[PREV PAGE] [NEXT PAGE]