Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


New Beetle L4-2.0L (AZG) (2003)

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Convertible Top Switch: > VG-US > Jun > 04 > Campaign - Convertible Top Button/Window Clamp Bolt > Page 689

Page 13
background image

-

Use new button, adjuster, pin and clip from repair kit (1YM 898 002)

-

Place and hold new adjuster with rubber washers in position in the latch bracket so the bottom groove on the adjuster aligns with latch bar in
release handle

NOTE:
-

Previously removed rubber washers -8- need to be reinstalled

-

Arrows in illustration show position of latch bracket. Rubber washers are inward of the bracket and adjuster -9- is in the middle

-

To install new button, hold it in previously noted position before disassembly and rearward of the latch bracket, then move button forward over
latch bracket and insert new pin

-

Raise release handle over new button

-

Press button and check function

-

Install new clip on pin

-

Proceed to Section C

Section C

Section C - Headlining Tensioning System Repair

TO BETTER UNDERSTAND THE FOLLOWING WORK SEQUENCE, PLEASE REFER TO THE PICTURES WHICH IDENTIFY THE
ASSEMBLED HEADLINING TENSIONING CABLE ROUTING AND DESCRIPTIONS:

NOTE:  All illustrations in this section are showing right side of vehicle unless identified as a left side illustration

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Convertible Top Switch: > VG-US > Jun > 04 > Campaign - Convertible Top Button/Window Clamp Bolt > Page 689

[PREV PAGE] [NEXT PAGE]