Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


New Beetle L4-2.0L (AZG) (2003)

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Convertible Top Switch: > VH-US > Jun > 04 > Campaign - Convertible Top/Front Window Clamp Bolts > Page 746

Page 10
background image

NOTE:  Sliding nuts outward brings window inward at the top

-

Tighten nuts and replace rubber covers when window is in correct position

-

Open door and place three pieces of tape along the top of the window as indicated in illustration -arrows-

-

Close door and mark depth of window entry into window slot

-

Open door; use a scale to measure window entry depth

-

Depth needed is 8 mm±1 (.28 in. - .35 in.)

NOTE:  This is the Z - window adjustment.

-

Remove rubber plugs on bottom of door; use a T30 Torx driver and turn screw clockwise to raise window or counterclockwise to lower window to
reach required depth

NOTE:  By turning Torx screw one revolution, window will move 1 mm (0.04 in.)

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > All Other Service Bulletins for Convertible Top Switch: > VH-US > Jun > 04 > Campaign - Convertible Top/Front Window Clamp Bolts > Page 746

[PREV PAGE] [NEXT PAGE]