New Beetle L4-2.0L (AZG) (2003)
-
Using a rivet (1Y0 871 996 A) secure cable eyelet -1- to upper hole -arrow- in frame
NOTE: Flat side of the cable eyelet must face frame
CAUTION: MAKE SURE UPPER HOLE IS USED, OTHERWISE LONG UPPER CABLE WILL NOT FUNCTION PROPERLY
-
Pull cord -arrow- tied to elastic cable until eyelet is outside the headlining
-
Partially secure eyelet on elastic cable with screw, remove string, and finish tightening screw
CAUTION: DO NOT ALLOW ELASTIC CABLE TO RETRACT INTO THE HEADLINING
-
Repeat procedure on opposite side of the vehicle
-
Close and fully open convertible top to make certain new cables are functioning correctly