Workshop Repair Manuals

Volkswagen Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volkswagen Workshop Repair Guides


New Beetle L4-2.0L (AZG) (2003)

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > Recalls: > VG-CAN > Jun > 04 > Campaign - Window Clamp Bolts/Convertible Top Button > Page 506

Page 11
background image

-

Turn ignition switch to "ON" position

-

Push and release PRESS button -arrow 7- and pull locking handle down

NOTE:  DO NOT pull on PRESS button

-

Turn handle -arrow 4- counterclockwise until it stops, then push convertible top upward, open it slightly and release the handle
-

Lift control switch and partially open the top

-

Raise door window and rear window to top position

-

Height -a- of both windows should be same; otherwise perform Z - axis adjustment

-

Distance -b- (measured horizontally near top of windows) must be equal to 9.5 mm±0.5 (0.35 in. - 0.39 in.) otherwise repeat Z - axis adjustment

NOTE:  Illustration is showing the left door window and rear glass

-

Reinstall rubber plugs at bottom of door

-

Repeat procedure on opposite door

-

Tighten the ground (GND) cable to battery to 5 Nm. (44 in. lbs.)

-

Perform power restoration procedure

-

Proceed to Section B

Section B

Section B - Convertible Top Button Replacement

Sensors and Switches > Sensors and Switches - Body and Frame > Convertible Top Switch > Component Information > Technical Service Bulletins > Recalls: > VG-CAN > Jun > 04 > Campaign - Window Clamp Bolts/Convertible Top Button > Page 506

[PREV PAGE] [NEXT PAGE]