New Beetle L4-2.0L (AZG) (2003)
-
Drill a 4.2±0.2 mm (.165±.008 in.) diameter hole using measurements in the diagram
NOTE: Diagram shows front and side views of hole location
IMPORTANT:
-
The frame must not be detached from the assembly to avoid possible malfunction
-
Ensure that headlining is protected before drilling hole, to avoid possible damage
Section E
Section E - Stopper Installation Check and Part Exchange
-
With the convertible top in the open position check the stopper on the left and right hinge covers for correct installation
-
If the long groove in the stopper -arrow- is in the forward position, the stopper installation is correct; NO exchange is required
-
If groove in the stopper is facing rearward, remove stopper from the left side hinge cover and reinstall it on the right side hinge cover; remove
stopper from the right side hinge cover and reinstall it on the left side hinge cover
NOTE: Illustration shows hinge cover open on left side of vehicle as viewed from the front passenger seat
-
Turn ignition switch to "ON" position, press control switch down and close the top
-
Pull down the handle for locking the top, turn handle counterclockwise as far as the stop, pull the top down and turn the handle clockwise
-
Push handle up into the recess