New Beetle L4-2.0L (AZG) (2003)
The bonded rubber bushing has a mark -1- on it's face.
This mark must align with the edge -arrow- of trailing arm -2-.
-
Mark position of marks -1- on bonded rubber bushing.
-
Assemble special tool with bonded rubber bushing.
-
Install bonded rubber bushing and special tool onto rear axle.
Make sure that mark aligns with the edge of trailing arm.
-
Pull in bonded rubber bushing by turning spindle.
-
Check position of bonded rubber bushing after installing.
The remainder of the installation is the reverse of removal.
Fastener/location Tightening torques:
Mounting bracket to rear axle ....................................................................................................................................................... 80 Nm (59 ft. lbs.)
Use new nuts and bolts!