New Beetle L4-2.0L (AZG) (2003)
Fig. 14 Assembling 1st and 2nd gear locking collar/synchro-hub
The locking collar has been pushed over the synchro-hub.
^
Insert locking pieces and install springs 120° offset. Angled end of spring must locate in hollow locking piece.
Fig. 15 Installation position of 1st and 2nd gear locking collar/synchro-hub
Identification groove (arrow -1-) and narrow collar (arrow -2-) of synchrohub point toward 1st gear.
Fig. 16 Pressing on 1st and 2nd gear locking collar/synchro-hub
Fig. 17 Installation position for 1st or 3rd gear outer ring
Lugs (arrows) face toward synchro-hub/locking collar -A