New Beetle L4-2.0L (AZG) (2003)
-
Open door and insert flat blade of screwdriver between handle trim -1- and handle and carefully pry trim off handle
-
Remove 2 screws -2- from behind trim -1-
-
Remove 3 screws -3- at bottom of door trim panel -4-
-
Using pliers tool 3392 unclip 6 retainers -6-
-
Lift door trim panel upward and out of window slot seal
-
Remove rubber grommets from holes -1- in the door inner panel
NOTE: The rubber grommet and hole at the front position is smaller than the rubber grommet and hole at the rear
-
Raise or lower window -4- position so the bolts 2- and -3- are visible through holes -1-
-
Ensure that ignition switch is in the "OFF" position
-
Open hood and disconnect the ground (GND) cable from the battery