New Beetle L4-2.0L (AZG) (2003)
-
Remove rubber grommets from holes -1- in the door inner panel
NOTE: Rubber grommet and hole at front position is smaller than rubber grommet and hole at rear
-
Raise or lower window position -4- so the bolts -2- and -3- are visible through holes -1-
-
Ensure that ignition switch is in the "OFF" position
-
Open hood and disconnect ground (GND) cable from battery
-
On door trim panel, unclip cable guide -1- using the flat blade of a screwdriver -2-, pull cable out of retainer -3- in direction of arrow and unhook
cable hook -4-
-
Disconnect electrical connectors to window switch, light, etc. and set door trim panel aside